← Products
Adapter Desk Mount
Active

PM-OFFICE-AD

Adapter Desk Mount

The adapter supports VESA 75x75 up to 100x100, making it suitable for displays ranging from 33cm to 69cm (13"-27"). Tiltable, Swivelable, and Turnable: Adjust your display to the angle with the adapter's tilting range …

ManualFAQ
PDF / print
Chapter 1 of 11

Adapter Bracket Assembly

Read the entire instruction manual before you start installation and assembly. If you have any questions regarding any of the instructions or warnings, please contact your local distributor.

Caution: Use with products heavier than the rated weights indicated may result in instability causing possible injury.

  • This product contains small items that could be a choking hazard if swallowed. Keep these items away from children.
  • Do not use this product for any purpose not explicitly specified by the manufacturer. Improper installation may cause property damage or even personal injury.
  • Make sure that the mounting surface can safely support the combined load of the equipment and all attached hardware and components.
  • Tighten screws firmly, but do NOT OVER TIGHTEN. Over tightening can cause damage to the items, greatly reducing their holding power.
  • The normal operating temperature is between 0°C to 40°C. Do NOT install this product near sources of heat.
  • Ensure your product is properly and securely assembled.

Note: Check the bracket for visible damage before use and periodically during assembly. If any parts are missing or faulty, telephone your local distributor for a replacement. Do not use substitute parts.

Note: MAINTENANCE: Check that the bracket is secure and be sure to regular tighten its bolt (at least every three months).

Chapter 2 of 11

PM-OFFICE-AD

75x75 100x100
13-27" 33-69cm
10kgx2 (22lbs)x2 RATED

PureLink GmbH
Von-Liebig-Str. 10 I 48432 Rheine I Germany
Phone: +49 (0) 5971 800 299 0

Note: PureLink GmbH hereby declares that this product complies with Directive 1907/2006/EU and 2011/65/EU.

Drawing of adapter bracket assembly

Chapter 3 of 11

Parts List

A (x2)

B (x1)
C (x2)
D (x1)

E (x2)
F (x2)
G (x2)
M6x30 (x4) H

M4x12 (x8) M-A
M5x12 (x12) M-B
4mm (x1) I
6mm (x1) I

D5 (x12) M-C
M5 (x4) M-D

Chapter 4 of 11

Step 1

  • Attach B to C using D and H.
  • Secure with I.
Chapter 5 of 11

Step 2

  • Attach A and F to each end with G.
Chapter 6 of 11

Step 3

  • Clip E onto the assembly.
Chapter 7 of 11

Step 4

  • Attach M-D and M-C to each side.
  • Secure with M-B.
Chapter 8 of 11

Step 5

  • Mount monitors as shown. Use correct screw combinations (M-A, M-B, M-C).
  • If needed, drill a 3mm pilot hole.
Chapter 9 of 11

Step 6

  • Adjust monitor tilt to ±45°.
  • Tighten using J.
Chapter 10 of 11

Step 7

  • Adjust for +15°/-15° tilt and 360° rotation.
Was this helpful?
← PreviousNext chapter →
Staff sign-in