Tilt Wall Mount

INSTALLATION MANUAL

PM-T400
200x200 | 300x300 | 400x200 | 400x400
26-52" (66-132 cm)
75kg (165lbs) RATED

PureLink GmbH
Von-Liebig-Str. 101 | 48432 Rheine | Germany
Phone: +49 (0) 5971 800 299 0

PureLink GmbH hereby declares that this product complies with Directive 1907/2006/EU and 2011/65/EU.

Read the entire instruction manual before you start installation and assembly. If you have any questions regarding any of the instructions or warnings, please contact your local distributor for assistance.

• CAUTION: Use with products heavier than the rated weights indicated may result in instability causing possible injury.
• CAUTION: Watch for moving parts. Use with products heavier than the rated weights indicated may result in instability causing possible injury.
• The wall structure must be solid and secure to support the load. This product should be mounted to wood studs or solid concrete walls only.
• Make sure that the mounting surface can safely support the combined load of the equipment and all attached hardware and components.
• The installer is responsible for ensuring that the wall mount is safely and securely mounted to the wall and attached hardware and components.
• Never exceed the maximum load capacity.
• Tighten screws firmly, but do NOT over-tighten by using excessive force.
• Be careful not to pinch fingers when handling bracket components.
• This product contains small parts that could present a choking hazard if swallowed. Keep these items away from children!

IMPORTANT: Read through the installation instructions completely before beginning assembly. If any parts are missing or faulty, telephone your local distributor for a replacement. Do NOT substitute with unauthorized parts.

MAINTENANCE: Check that the bracket is secure and safe to use at regular intervals (at least once every three months).

Tilt Wall Mount – Step 2a

1a

• Use for wood stud or wooden wall installation
• Use a spirit level, tape measure and pencil to mark locations
• Drill pilot holes (5.5mm)
• Insert G
• Attach mount with screws and washers

1b

• Use for concrete or brick wall installation
• Use a spirit level, tape measure and pencil to mark locations
• Drill holes (10mm)
• Insert H
• Attach mount with screws and washers

Tilt Wall Mount – Step 2a

• Only use for TVs with flat back
• Use A (M5x14) or B (M6x14) and D

Step 2b

• Use for TVs with uneven/obstructed back
• Use B (M6x30), C (M8x30), or C (M8x50)
• Spacer E and washer F as required

Step 3

• Hang TV on wall plate
• Tighten locking screw with screwdriver
• Tilt: +5° -10°
• 2 persons recommended

Legal & Compliance

Product identification

Model: PM-T400 – manual version 1.0

Warranty and liability

The manufacturer grants the full statutory warranty on all new devices. As the manufacturer has no influence on installation, the warranty only applies to the product itself. If you detect a fault or damage, please contact your dealer and provide your sales slip or invoice as proof of purchase.

The manufacturer is not liable for damage to persons or property caused by improper installation, operation or maintenance not described in this manual. Do not alter or modify the product or its accessories. Any use other than described in this manual is not permitted and voids warranty and guarantee.

Trademarks and disclaimer

Product model and logo are trademarks. All other company and product names mentioned are trademarks of their respective owners. All rights reserved. No part of this publication may be copied or reproduced without prior written permission. We reserve the right to make changes to the device, packaging or manual and accept no liability for misprints.

Packaging

Dispose of packaging separately by material (paper/cardboard, plastics) via the local collection systems. Keep packaging material away from children – risk of suffocation. Packaging register LUCID: DE5958616449295.