Safety precautions

To insure the best from the product, please read all instructions carefully before using the device. Save this manual for further reference.

• Unpack the equipment carefully and save the original box and packing material for possible future shipment
• Follow basic safety precautions to reduce the risk of fire, electrical shock and injury to persons.
• Do not dismantle the housing or modify the module. It may result in electrical shock or burn.
• Using supplies or parts not meeting the products’ specifications may cause damage, deterioration or malfunction.
• Refer all servicing to qualified service personnel.
• To prevent fire or shock hazard, do not expose the unit to rain, moisture or install this product near water.
• Do not put any heavy items on the extension cable in case of extrusion.
• Do not remove the housing of the device as opening or removing housing may expose you to dangerous voltage or other hazards.
• Install the device in a place with fine ventilation to avoid damage caused by overheat.
• Keep the module away from liquids.
• Spillage into the housing may result in fire, electrical shock, or equipment damage. If an object or liquid falls or spills on to the housing, unplug the module immediately.
• Do not twist or pull by force ends of the optical cable. It can cause malfunction.
• Do not use liquid or aerosol cleaners to clean this unit. Always unplug the power to the device before cleaning.
• Unplug the power cord when left unused for a long period of time.
• Information on disposal for scrapped devices: do not burn or mix with general household waste, please treat them as normal electrical wastes.

Introduction to PT-HDBT-701-RXAD

The PT-HDBT-701-RXAD is an Ultra-thin HDBaseT Receiver designed with audio de-embedded outputs. It receives 4K/1080p HDMI signal via CAT5e/CAT6a cable from HDBaseT Transmitter or Matrix Switcher at 40m/70m. It supports unidirectional PoH function, the receiver can be powered by HDBaseT Transmitter or Matrix Switcher.

Feature

• Supports HDMI1.4 & HDCP2.2, and is backward compatible to the previous version.
• Maximum transmission distance is up to 40m (131ft) at 4Kx2K, and 70m (230ft) at 1080p.
• Supports bi-directional IR and RS232 pass-through for long-distance control.
• Supports unidirectional PoH for simplified wiring, and compatible with 48VDC PoC, the HDBaseT Receiver can be powered by HDBaseT Transmitter or Matrix Switcher.
• Supports audio de-embedded outputs.

Package Content

• 1 x PT-HDBT-701-RXAD Receiver
• 2 x Mounting Ears & 2 x Screws
• 1 x User Manual
• 1 x 3-Pin Phoenix Connector (Male)
• 4 x Plastic Cushions

Panel Description

Front Panel

HDCPLINK UPDATE A CTRL UPDATE B # 1 2 3 4

Rear Panel

Tx Rx RS232 DC 12VIR OUT HDMI OUT HDBT IN AUDIO OUT OPTICAL OUTIR IN COAX OUT # 1 2 3 4 5 6 7 8 9

Specification

System Diagram

Tx Rx Tx Rx IR Receiver TV Remote Laptop IR Emitter HDTV 4K 40m, 1080P 70m Soundbar PT-HDBT-702-TX PT-HDBT-701-RXAD Speaker HDMI: HDBaseT: RS232: IR: Audio:

After-Sales Service

If there appear some problems when running the product, please check and deal with the problems referring to this user manual. Any transport costs are borne by the users during the warranty.

1. Product Limited Warranty: This product will be free from defects in materials and workmanship for two years (The purchase invoice shall prevail). Proof of purchase in the form of a bill of sale or receipted invoice which is evidence that the unit is within the Warranty period must be presented to obtain warranty service.
2. What the warranty does not cover (servicing available for a fee): • Warranty expiration. • Factory applied serial number has been altered or removed from the product. • Damage, deterioration or malfunction caused by: • Normal wear and tear. • Use of supplies or parts not meeting our specifications. • No certificate or invoice as the proof of warranty. • The product model showed on the warranty card does not match with the model of the product for repairing or had been altered. • Damage caused by force majeure. • Servicing not authorized by distributor. • Any other causes which does not relate to a product defect. • Delivery, installation or labor charges for installation or setup of the product.
3. Technical Support: For any questions or problems, contact your distributor or reseller and tell them the respective product name and version, the detailed failure situation as well as the formation of the cases.

Technical Support

Phone: +49 5971 800299 - 0
Fax: +49 5971 800299 – 99

Technical Support Hours

• 8:30 AM to 5:00 PM Monday thru Thursday
• 8:30 AM to 4:00 PM Friday

Write to

PureLink GmbH
Von-Liebig-Straße 10
D - 48432 Rheine
www.purelink.de
info@purelink.de

Legal & Compliance

Product identification

Model: PT-HDBT-701-RXAD – manual version 1.0

Trademarks and disclaimer

Product model and logo are trademarks. All other company and product names mentioned are trademarks of their respective owners. All rights reserved. No part of this publication may be copied or reproduced without prior written permission. We reserve the right to make changes to the device, packaging or manual and accept no liability for misprints.

EU conformity

PureLink hereby declares that this product PureTools PT-HDBT-701-RXAD complies with Directives 1907/2006/EU und 2011/65/EU. PureLink GmbH hereby declares that this product PureTools PT-HDBT-701-RXAD complies with Directives 2014/30/EU and 2014/35/EU.

The full text of the EU Declaration of Conformity is available at: http://www.purelink.de/ce/4251364706756_CE.pdf

FCC

Statement This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. It has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a commercial installation.

Disposal of electrical and electronic equipment

WEEE reg. no.: DE 93847290

The crossed-out wheelie bin symbol on the product, packaging or in this manual means that electrical and electronic equipment must not be disposed of with household waste at the end of its life. Hand in old devices free of charge at a public collection point or return them to a distributor obliged to take them back. Remove batteries and lamps that can be removed without destroying the device before handing it in, and delete any personal data stored on the device. Details are regulated by national law. By returning old devices you help protect the environment.

Packaging

Dispose of packaging separately by material (paper/cardboard, plastics) via the local collection systems. Keep packaging material away from children – risk of suffocation. Packaging register LUCID: DE5958616449295.