Introduction

Thank you for purchasing the Fiber Optic HDMI 8K@60Hz AOC Cable.
This Cable allows you to transmit HDMI signals to a distance of up to 100m without external power supply. This cable is a hybrid cable containing both fiber optic and copper cores. Our HDMI Active Hybrid Cable is the most competitive long distance HDMI interconnection solution on the market. It supports a maximum data rate of 16 Gbps per channel, is light weight, flexible, and has an ultra-small fixed installation bending radius of 45mm.
With our advanced optical engine embedded the HDMI Hybrid Cable provides full HDMI signal integrity.

Intended Use

This product is intended for indoor use only. Do not use it outdoors. Contact with moisture, e.g. in bathrooms, must be avoided under all circumstances.
For safety and approval purposes (CE), you must not rebuild and/or modify this product. If you use the product for purposes other than those described above, the product may be damaged. In addition, improper use can cause hazards such as short circuiting, fire, electric shock etc.
Read the instructions carefully and keep them. Make this product available to third parties only together with its operating instructions.

Safety Instructions

Read the operating instructions carefully and especially observe the safety information. If you do not follow the safety instructions and information on proper handling in this manual, we assume no liability for any resulting personal injury or damage to property. Such cases will invalidate the warranty/guarantee.

• The device is not a toy. Keep it out of the reach of children and pets.
• The minimum bending radius of the hybrid cable is approximately 45mm, bending the cable to a smaller radius will irreversibly destroy the cable.
• Pay attention to trip hazards; make sure that the cable is installed safely.
• Do not leave packaging material lying around carelessly. These may become dangerous playing material for children.
• Protect the product from extreme temperatures, direct sunlight, strong jolts, high humidity, moisture, flammable gases, vapors and solvents.
• Do not place the product under any mechanical stress. If it is no longer possible to operate the product safely, take it out of operation and protect it from any accidental use.

Safe operation can no longer be guaranteed if the product:
• is visibly damaged
• is no longer working properly
• has been stored for an extended period in poor ambient conditions or
• has been subjected to any serious transport-related stresses.
Please handle the product carefully. Jolts, impacts or a fall even from a low height can damage the product.
Also observe the safety and operating instructions of any other devices which are connected to the product.
Consult an expert when in doubt about the operation, safety or connection of the device.

Delivery Content

• 1x HDMI 8K@60Hz AOC Cable
• 1x User Manual DE/EN
• 1x Warning Insert

Features

• Supports HDMI 8K@60Hz specification with data rates up to 18Gbps
• Supports HDCP1.4 & HDCP2.2
• Supports resolutions up to Ultra HD 8K (3840x2160) 60Hz, 4:4:4
• Supports computer resolutions including 1080P and 4K2K (60Hz)
• Supports 48 bit color depth (16bit per channel)
• Supports lossless HDMI audio formats like Dolby True HD and DTS-HD, etc.
• Supports ARC, HEC and CEC
• Supports EDID incl. self-detecting function
• Long-term bending radius (45mm)
• Plug and Play
• Low Power Consumption: 250mW (max) (Power Required)
• No loss of signal
• Delivering crystal clear digital images instantly

Application

• Digital Signage
• LED Signboards
• Home Theater
• Blu-ray, 3D Video, Projector, Set-top box, DVR, Game Consoles and Computer
• TV Broadcast Station
• Conference Room
• Video Equipment
• Security Systems
• ... and more

Specifications

*D = the diameter of the cable body, in this case it is 4.5mm

Environmental Conditions

Cross Section

Construction:
Hybrid cable, fiber (high speed data) & copper (low speed signals)
Cable construction:
4 fiber cores and 7 copper conductors
Cable jacket: PVC / TPU,
Diameter: ~ 4.5mm
Connector dimensions: ~ 39x 20 x 9 mm
Connector material: Zinc Alloy

• Aluminum foil and mylar
• Aramid yarns
• Insulating layer
• Copper
• Fiber
• Aluminum foil
• Sheath

Operation and Connection Diagram

Note: The X-AOC250 series is designed for use with the +5V passive power, supplied through pin 18 on the HDMI connection from the source device. This +5V connection, as well as powering the internal fiber optic module, is also carried through to the other sink via a full standard copper connection. Please make sure, that the source device is capable of delivering more than 500mA.

This cable can only be used in one direction. The connectors are marked with “SOURCE” and “DISPLAY”. Each connector must be plugged into the correct port to avoid signal loss.
Before using this cable, please make sure that all devices which will be connected with the AOC HDMI Cable are shut down and without power.
Then you can start to connect the “source side” of the HDMI plug to the transmitter and connect the “display side” of the other HDMI plug to the receiver/display.
This works without additional power supply.
We do not recommend using any intermediate cables or adapters between the connections, as the signal transmission performance maybe attenuated.
Switch on the power of the device of the HDMI source and the display.

Connect to Source
Connect to Display
If the system does not work properly, see trouble shooting guide in next section.

Troubleshooting

• The Display shows:
• A black screen
• Screen is distorted
• Noise interference

1. Check that the connectors are in the correct ports of the source and sink devices – check the labels on the connector housing to be sure.
2. Ensure that the HDMI plugs are firmly inserted into the HDMI source and display.
3. Check if the HDMI source and display are powered on and properly booted.
4. Reset the system by unplugging and re-plugging the source or display HDMI port.
5. Re-boot the system with the optical HDMI cable system reconnected.

Maintenance

There are no components located inside the product you need to maintain. Never open/dismantle the product.
Maintenance, modifications and repairs are to be performed exclusively by an expert or at a qualified shop.
If you have questions which remain unanswered by these operating instructions, contact our technical support service or other technical personnel.

Cleaning

Before cleaning the product it must be disconnected from all other connected products.
Do not use abrasive or solvents or any aggressive cleaning agents, rubbing alcohol or other chemical solutions as they can cause damage to the housing and malfunctioning.
To clean the product, a dry, soft and clean cloth is sufficient. Do not apply too much pressure to the housing as this may cause scratch marks. You can easily remove dust using a long-haired, soft and clean brush.

Warranty and Liability

The producer grants 2 years warranty to a new device.
As the manufacturer has no influence on installation, warranty only applies to the product itself.
If any fault or damage is detected on your product, please contact your dealer and provide your sales slip or invoice as evidence of the purchase, if necessary. Your dealer will repair the fault either on site, or send the device to the manufacturer. You make the work of our technicians considerably easier, describing possible faults in detail – only then you can be assured that faults, occurring only rarely, will be found and repaired with certainty!
The manufacturer is not liable for damages to persons or property caused by improper installation, operation or maintenance, not described in this manual.
Do not alter or modify the product or its accessories.
Any use other than described in this user`s manual is not permitted and causes loss of warranty, loss of guarantee, and non-liability.

CE Conformity

PureLink GmbH hereby declares that the X-AOC250 Series complies with Directive 2014/30/EU.
The full text of the EU Declaration of Conformity is available at the following Internet address:
www.purelink.de/ce/X-AOC250-XXX_CE.pdf

Disposal of the Device

WEEE-Reg. No.: DE 93847290
According to the European WEEE directive, any electrical and electronic equipment must not be disposed with consumers waste. As a consumer, you are committed by law to reposit electrical and electronic devices to public collecting points or to the dealer for free at the end of the device’s lifetime. Details are regulated in the respective national legislations. The garbage can symbol on the product, in the manual or on the packaging refers to these terms. With the return of your used devices you actively take part in protecting the environment.

Disclaimer

This product complies with the statutory national and European requirements. All company names and product names are trademarks of their respective owners.
All rights reserved.
We reserve our right for misprints and changes of the device, packing or user`s manual.
HDMI® is a registered trademark of HDMI Licensing L.L.C
Dolby and the double-D symbol are registered trademarks of Dolby Laboratories.

Legal & Compliance

Product identification

Models: X-AOC250-100, X-AOC250-150, X-AOC250-200, X-AOC250-250, X-AOC250-300, X-AOC250-400, X-AOC250-500 – manual version 1.0

Packaging

Dispose of packaging separately by material (paper/cardboard, plastics) via the local collection systems. Keep packaging material away from children – risk of suffocation. Packaging register LUCID: DE5958616449295.