← Products
Speaker Wall Mount for Sonos® One, Sonos® One SL, Sonos® Play1, black
DiscontinuedReplaced by PM-SOM-050

PM-SOM-100

Speaker Wall Mount for Sonos® One, Sonos® One SL, Sonos® Play1, black

The PureMounts PM-SOM-100 is a steel speaker wall mount designed for Sonos One, Sonos One SL, and Sonos Play:1, with a distance to wall of 129mm and a load capacity of 3kg. It features a tilt range of 0/-20°, a swivel …

ManualFAQHas successor
PDF / print
Chapter 1 of 7

PM-SOM-100 / PM-SOM-101

3Kg (6.6 lbs) RATED
PureLink GmbH
Von-Liebig-Str. 10 | 48432 Rheine | Germany
Phone: +49 (0) 5971 800 299 0

PureLink GmbH hereby declares that this product complies with Directive 1907/2006/EU and 2011/65/EU.

Read the entire instruction manual before you start installation and assembly. If you have any questions regarding any of the instructions or warnings, please contact your local distributor.

Caution: Use with products heavier than the rated weights indicated may result in instability causing possible injury.

  • This product is designed for use in wood stud walls only! Installation should be carried out by qualified persons only.
  • Pay attention to the maximum load capacity. Exceeding maximum load capacity may result in severe personal injury.
  • Read instructions carefully before installation. PureMounts cannot be liable for damage or injury caused by incorrect mounting, incorrect assembly or incorrect use.
  • This product should only be installed on solid concrete, solid bricks or concrete block walls and attached hardware and components.
  • This product is not designed for use in metal stud walls. Severe personal injury and/or property damage may occur.
  • Tighten screws firmly but do NOT OVER TIGHTEN.
  • The included mounting hardware is not suitable for metal studs. Please check before you buy and before installation.
  • Assemble and install with care. Injury and/or damage can be caused by dropping or mishandling the product.
  • Dispose of packing material properly. Small children and pets should be kept away from packaging material. If any parts are missing or faulty, contact your place of purchase for a replacement.
  • Maintenance: Check that the product is secure and safe to use at regular intervals (at least every three months).
Chapter 2 of 7

Step 1

Remove the front cover from part A.

Chapter 3 of 7

Step 2a

For installation on wood or MDF panel.

  • Drill holes (diameter and spacing as specified in illustration).
  • Insert mounting part through the panel.
  • Ensure panel thickness as shown. Do not use wall plugs.
  • Fasten with screws E from the other side. Attach cover C.
  • Use correct screw hole orientation as per illustration.
Chapter 4 of 7

Step 2b

For installation on a solid wall.

  • Drill holes (diameter and spacing as specified in illustration).
  • Insert wall plugs D.
  • Fasten with screws E. Attach cover C.
  • Use correct screw hole orientation as per illustration.
Chapter 5 of 7

Step 3

  • Attach bracket B to part A.
  • Insert and secure screw G as shown.
Chapter 6 of 7

Step 4

  • Attach safety cable F using screw H.
  • Adjust rotation angle as required (±45°, ±180°, 0°, -20°).
Was this helpful?
← PreviousNext chapter →
Staff sign-in