Introduction

Thank you for purchasing the FX-P350 / FX-P355, a pair of HDMI 2.0 Single Fiber Pigtail Extenders. With the optical Extender, you are immediately able to transmit 4K content via a Single Fiber optical glass fiber cable over distances of up to 1,000 m to TV devices. The dongle provides all the hardware and firmware necessary to support the full 18Gbps HDMI signal bandwidth as well as HDCP content protection.

Intended Use

Use is only permitted indoors; outdoor use is not allowed. Contact with moisture, e.g. in bathrooms or similar environments, must be strictly avoided. For safety and approval reasons (CE), you must not modify and/or alter the product. If you use the product for purposes other than those described above, the product may be damaged. Furthermore, improper use may cause hazards such as short circuits, fire, electric shock, etc.

Read the user manual thoroughly and keep it. Only pass the product on to third parties together with the user manual.

Safety Instructions

Read the user manual carefully and pay special attention to the safety instructions. If you do not follow the safety instructions and the information on proper handling in this user manual, we accept no liability for any resulting personal or property damage. In addition, the warranty will be void in such cases.

Caution: Use of controls or adjustment of performance settings other than those specified herein may expose you to dangerous radiation.

Note: This product is not a toy. Keep it away from children and pets. Do not leave packaging materials lying around carelessly. These could become a dangerous toy for children. Danger of suffocation!

Note: Watch out for tripping hazards; ensure the cable is securely installed.

Note: Protect the product from extreme temperatures, direct sunlight, strong vibrations, high humidity, moisture, flammable gases, vapors, and solvents.

Note: Do not subject the product to mechanical stress.

Note: If safe operation is no longer possible, take the product out of service and protect it from unintended use.

• shows visible damage,
• no longer functions properly,
• has been stored for an extended period under unfavorable environmental conditions, or
• has been subjected to significant transport stress.

Handle the product carefully. Impacts, shocks, or drops even from a low height can damage the product. Also observe the safety instructions and operating manuals of other devices connected to the product.

Note: If in doubt, contact a specialist if you have questions about the operation, safety, or connection of the product.

Scope of Delivery

• 1x HDMI 2.0 Single Fiber Pigtail Transmitter (TX)
• 1x HDMI 2.0 Single Fiber Pigtail Receiver (RX)
• 2x USB cables
• 1x user manual DE/EN

Product Features

The powerful HDMI 2.0 Single Fiber Pigtail Extender offers you versatile features, such as:

• Full 18Gbps transmission bandwidth over single fiber optic cable

• Resolutions up to 4K@60Hz 4:4:4 including HDR 10, HDR 12, and Dolby Vision
• HDMI 2.0, HDMI 1.x and DVI 1.0 compatible
• HDCP 2.2, HDCP 1.4 compatible
• Supports CEC and transparent EDID
• Delay-free, no latency, no compression

• Single Multi Mode fiber optic cable up to 1,000m - SC connector
• Supports all HDMI audio formats including Dolby TrueHD and DTS-HD Master Audio
• Easy plug & play installation
• Status LED for easy troubleshooting
• Metal housing for optimized EMI protection and cooling
• Secure Lock HDMI connector / Ultra Lock HDMI connector

Application

This product is suitable for the following applications:

• Digital Signage
• LED Signboards
• Home Theater
• Extension of Blu-ray, 3D video, projectors, set-top boxes, DVRs, gaming consoles, and computers
• Broadcasts
• Conference Rooms
• Video Devices
• Security Systems

Specifications

Audio, Video & Optical

General Information

Operating and Connection Diagram

1. Remove Transmitter and Display Receiver from packaging.
2. Connect USB cable to Transmitter.
3. Connect USB cable to Display Receiver.
4. Connect source HDMI and USB cables to HDMI video source (label with source arrow on the back).
5. Connect display HDMI and USB cables to the HDMI display (label with display arrow on the back).
6. Connect one end of the SC fiber optic cable to the Transmitter.
7. Connect the other end of the SC fiber optic cable to the Display Receiver. The cable automatically synchronizes with the source.

Note: It is explicitly recommended to power on the device as the last step of your work.

Troubleshooting / Status LED

Maintenance

There are no user-serviceable parts inside the product; therefore, never open/disassemble it.
Maintenance, adjustments and repairs must be carried out exclusively by a qualified technician or specialist service.
If you have further questions that are not answered in this manual, please contact our technical support or an expert.

Cable Connection Status

Maintenance

Cleaning

Clean the SC connection only with a suitable fiber optic cleaner such as a one-click cleaner.
The use of other product types for cleaning can irreparably damage the fiber optic port.
Before each cleaning, disconnect the product from other connected devices. Make sure the dust cap is always in place when the product is not connected to an SC cable.

Note: Under no circumstances use aggressive cleaners, cleaning alcohol or other chemical solutions as these may damage the housing or impair the functionality. Ensure that no cleaning products or solvents enter or get near the fiber optic port, even if the dust cover is attached.

For cleaning, a dry, soft and clean cloth is sufficient. Do not press too hard on the housing as this may cause scratch marks.

Dust can be easily removed with a long-haired, soft and clean brush.

Warranty and Liability

The manufacturer grants the statutory warranty on a new product.
Since the manufacturer has no influence on the installation of the product, its liability extends only to the product itself.
If you detect a fault or defect in your product, please contact your specialist dealer and present your receipt or invoice as proof of purchase.
Your dealer will either fix the fault on site or forward the product to the manufacturer. You make our technicians' work much easier if you describe any errors in detail – only then can you ensure that even rare faults are reliably found and eliminated!

Note: The manufacturer is not liable for personal injury or property damage caused by improper installation, operation or maintenance not described in this manual.
Do not alter or modify the product and its accessories.

Caution: Any use other than described in this manual is not permitted and will result in loss of warranty, guarantee and liability.

CE Compliance

PureLink GmbH hereby declares that FX-P350 / FX-P355 complies with Directive 2014/30/EU.
The full text of the EU declaration of conformity is available at the following internet address:

www.purelink.de/ce/4251364712146_CE.pdf www.purelink.de/ce/4251364712153_CE.pdf

Device Disposal

WEEE Reg. No.: DE 93847290

Electrical and electronic devices must not be disposed of with household waste according to the European WEEE Directive. As a consumer, you are required under ElektroG to return electrical and electronic devices free of charge at the end of their lifespan to designated public collection points or to the point of sale. Details are regulated by the respective national law. The symbol on the product, instruction manual or packaging indicates these regulations. This type of recycling of old devices contributes significantly to environmental protection.

FCC Declaration of Conformity

This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Note: This device has been tested and complies with the limits for a Class B digital device according to section 15 of the FCC rules. These limits provide reasonable protection against harmful interference in residential installations.
This device generates and uses radio frequency energy which may radiate and cause harmful interference to radio or television reception if not installed and used in accordance with the manufacturer's instructions. However, there is no guarantee that interference will not occur in a particular installation.

If this device causes interference to radio or television reception, which can be checked by switching the device on and off, the user should attempt to correct the interference by one or more of the following measures:

• Realign your receiving antenna or place it in another location.
• Increase the distance between the device and receiver.
• Connect the device to an outlet not supplied by the same circuit as the receiver's outlet.
• Contact the dealer or an experienced radio/TV technician.

Caution: Any changes or modifications to the device not expressly approved by PureLink may void the electromagnetic compatibility (EMC) and result in the loss of the device’s operating license.

This product complies with EMC guidelines and has been tested with compatible peripheral devices and shielded cables for connections between these devices. It is important that you use compatible peripheral devices and shielded cables between system components to minimize the risk of interference from radios, televisions, and other electronic devices.

Note: Information about radio frequencies: The emitted signals of this device are within the FCC/IC limits for radio frequencies. When using this device, ensure a minimum distance of 20 cm between the technical equipment and the user’s body is maintained.

Responsible company
(contact for FCC matters only):
PureLink GmbH
Von-Liebig-Straße 10
48432 Rheine
Germany

Disclaimer

The product complies with legal, national, and European requirements. All company names and product designations contained are trademarks of their respective owners.

All rights reserved.
We reserve the right to correct printing errors and make changes to the device, packaging or manual.

HDMI® is a registered trademark of HDMI Licensing L.L.C.
Dolby and the double-D symbol are registered trademarks of Dolby Laboratories.

Legal & Compliance

Product identification

Model: FX-P355 – manual version 1.0

Packaging

Dispose of packaging separately by material (paper/cardboard, plastics) via the local collection systems. Keep packaging material away from children – risk of suffocation. Packaging register LUCID: DE5958616449295.