← Products
TV Mount - Swivel - Vesa 200
Active

PM-FM11-200

TV Mount - Swivel - Vesa 200

Adjust the tilt of your TV from 3° up to -10° and swivel it 90° up to -90°, depending on the wall distance and screen width. The mount allows for a wall distance ranging from 56mm up to 300mm. With a maximum load …

ManualSpecifications
PDF / print
Chapter 1 of 9

Full Motion LED, LCD TV Wall Mount

PM-FM11-200

Read the entire instruction manual before you start installation and assembly. If you have any questions regarding any of the instructions or warnings, please contact your local distributor for assistance.

Caution: Avoid potential personal injuries and other potential hazards. Improper installation may result in instability causing possible injury.

Caution: Assemble the product only as specified by the included instructions. Improper assembly may result in injury or serious personal injury.

Note: Securely fasten all screws and ensure that all attachments are firmly fixed before use.

Caution: Do not exceed the maximum load capacity specified for this product.

Caution: This product should be installed by at least two adults. Improper installation may result in death or serious injury.

Note: The manufacturer assumes no responsibility for any damage or injury caused by defective assembly and all attached hardware and components.

Caution: Use mounting hardware provided by the manufacturer only. Otherwise the device may become unstable.

Note: This product may only be used for its intended purpose. Please observe the mounting and installation instructions.

Caution: Do not use this product outdoors or in damp locations.

IMPORTANT: Ensure that you have received all parts according to the parts list. If any parts are missing or faulty, telephone your local distributor for a replacement. Do not substitute with foreign parts.

Note: MAINTENANCE: Check that the bracket is secure and safe to use at regular intervals (at least every three months).

PureLink GmbH
Von-Liebig-Str. 10 | 48432 Rheine | Germany
Phone: +49 (0) 5971 800 299 0

Note: PureLink GmbH hereby declares that this product complies with Directive 1907/2006/EU and 2011/65/EU.

VESA PatternsScreen SizeRated Load
100x10023-42" (58–107 cm)20kg (44lbs)
200x100
200x200
Chapter 2 of 9

Parts List

  • A (x1)
  • B (x2)
  • M4x14 (x4) M-A
  • M5x14 (x4) M-B
  • M6x14 (x4) M-C
  • M8x20 (x4) M-D
  • D5 (x4) M-E
  • D8 (x4) M-F
  • M-G (x8)
  • W-A (x3)
  • W-B (x3)
  • W-C (x3)
Chapter 3 of 9

Step 1

  • Attach bracket A to arm using screws as shown.
Chapter 4 of 9

Step 2

  • Position the mount on wall, use a level. Mark holes.
  • Drill holes (10 mm x 50 mm).
  • Insert W-A anchors, fasten the bracket using W-B screws and W-C washers.
  • Only use in solid concrete or brick.
Chapter 5 of 9

Step 3

  • Attach B covers to the arm ends.
Chapter 6 of 9

Step 4

  • Select correct screws (M-A, M-B, M-C, or M-D) and spacers (M-E, M-F, M-G).
  • Attach the mounting plate to the back of your TV as shown.
Chapter 7 of 9

Step 5

  • With assistance, hook and secure TV plate onto the arm assembly.
  • Tighten the screws to secure.
Chapter 8 of 9

Step 6

  • Adjust angle: +3° to -10° tilt, 180° swivel.
Was this helpful?
← PreviousNext chapter →
Staff sign-in