← Products
Desk Mount - 4 Screen
Discontinued

PM-OFFICE-04

Desk Mount - 4 Screen

The PureMounts Monitor Desk Mount 4-fold is a desk mount for four monitors, with each arm offering tilt from 45° to -45°, swivel from 90° to -90° (depending on screen width), and 360° rotation, while the middle joint is …

ManualFAQ
PDF / print
Chapter 1 of 9

Installation Manual

Read the entire installation manual before you start installation and assembly. If you have any questions regarding any of the instructions or warnings, please contact your local distributor for assistance.

Caution: Use with products heavier than the rated weights indicated may result in instability causing possible injury.

Caution: The manufacturer will not be held liable for damage or injury caused by incorrect mounting, assembly or use. Do not exceed the maximum weight indicated.

Note: To ensure a safe installation, this product must only be installed by professionals who have read and understood these instructions and who are aware of the relevant standards regarding mounting electronic equipment.

Note: Make sure the mounting surface is strong enough to support the combined load of the equipment and all attached hardware and components. Tighten screws firmly, but do not over-tighten them.

Note: Check the product at regular intervals to make sure that it is safe and secure. If you have any doubts, or if you notice damage or faulty, telephony your local distributor for assistance.

Note: Maintenance: Check that the brackets are secure and safe on a regular basis (should not be every three months).

PM-OFFICE-04
75x75 | 100x100

13-27'' 33-69cm
Load 8kg/Monitor

PureLink GmbH
Von-Liebig-Str. 10 | 48432 Rheine | Germany
www.purelink.de
Phone: +49 (0) 5971 800 299 0

PureLink GmbH hereby declares that this product complies with Directive 1907/2006/EG and 2011/65/EU.

Chapter 2 of 9

Step 1a

  • Insert G and H into D.
  • Secure D to the desk edge (10-88mm) using F and K.
  • Tighten with a screwdriver.
Chapter 3 of 9

Step 1b

  • Assemble D and E together.
  • Insert B and G, and secure with K.
  • Slide and secure onto the desk (10-88mm) with J and tighten.
Chapter 4 of 9

Step 2

  • Insert the upright pole and secure using K.
Chapter 5 of 9

Step 3

  • Attach A (monitor arms) to the upright pole.
  • Secure with L.
Chapter 6 of 9

Step 4

  • Insert C and F into assembly.
  • Tighten and secure with K.
  • Align bracket and attach to upright using K.
Chapter 7 of 9

Step 5

  • Adjust height on the upright pole.
  • Secure with L.
Chapter 8 of 9

Step 6

  • Ensure correct screw and spacer selection (M-A, M-B, M-C).
  • For recessed holes, use a 3mm spacer.
  • Attach monitor to the arm assembly with the correct screws.
Was this helpful?
← PreviousNext chapter →
Staff sign-in