INSTALLATION MANUAL

Please read this instruction manual before you start installation and assembly. If you have any questions regarding any of the instructions or warnings, please contact your local distributor for assistance.

Caution: Be careful during installation. Injury or damage to property may result from dropping or mishandling the product.

• For safety reasons, keep children away from the work area and product.
• Use proper equipment, tools, and personal protection during installation.
• Before installing, make sure supporting surface will safely support the combined load of the monitor and mount and components.

• Tighten screws securely but do not over-tighten.
• This product contains small items that could be a choking hazard if swallowed. Keep these items away from children.

Note: MAINTENANCE: Check that the product is secure and safe and do not re-tighten (loosen) any part more than needed.

PUREMounts
Monitor desk stand illustration
PM-OFFICE-ST-02
75x75/100x100
17-27'' 43-69cm
15kg / screen
PureLink GmbH

Von-Liebig-Str. 10 | 48432 Rheine | Germany
Phone: +49 (0) 5971 800 299 0
PureLink GmbH hereby declares that this product complies with Directive 1907/2006/EU and 2011/65/EU.

Step 6

Note: Please make sure you attach same monitors on the table stand otherwise the table stand might be inverted. Also, while you are installing a monitor on the one side, another person should hold the other side of the mount to keep the table stand stable.

• Too long
• Too short

Step 7

Note: Adjust to the desired angle then tighten the screws using the Allen key as shown, alternating from each screw as you tighten them.

Parts List

• A (x1)
• B (x1)
• C (x2)
• D (x4)
• E (x1)
• F (x1)
• G (x2)
• H (x1)
• I (x1)
• J (x1)
• K (x1)
• L (x2) M6x20
• M (x4) M6x30
• N (x1) M6x16
• O (x6) M4x12
• P (x2) M6x35
• Q (x1) M6x40
• R (x1) 4mm
• S (x1) 5mm
• T (x1) 6mm
• M-A (x4) M4x12
• M-B (x4) M5x12
• M-C (x4) DS
• x2

Step 1 / Step 2

Caution: To avoid possible injury do not use or operate the handle before the installation is complete.

Step 3 / Step 4 / Step 5

Legal & Compliance

Product identification

Model: PM-OFFICE-ST-02 – manual version 1.0

Warranty and liability

The manufacturer grants the full statutory warranty on all new devices. As the manufacturer has no influence on installation, the warranty only applies to the product itself. If you detect a fault or damage, please contact your dealer and provide your sales slip or invoice as proof of purchase.

The manufacturer is not liable for damage to persons or property caused by improper installation, operation or maintenance not described in this manual. Do not alter or modify the product or its accessories. Any use other than described in this manual is not permitted and voids warranty and guarantee.

Trademarks and disclaimer

Product model and logo are trademarks. All other company and product names mentioned are trademarks of their respective owners. All rights reserved. No part of this publication may be copied or reproduced without prior written permission. We reserve the right to make changes to the device, packaging or manual and accept no liability for misprints.

Packaging

Dispose of packaging separately by material (paper/cardboard, plastics) via the local collection systems. Keep packaging material away from children – risk of suffocation. Packaging register LUCID: DE5958616449295.